Subject: | |
From: | |
Reply To: | |
Date: | Thu, 14 Mar 2013 09:55:11 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Paul,
What section in 6012? Regards Steve
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Paul Reid
Sent: March-14-13 8:25 AM
To: [log in to unmask]
Subject: Re: [TN] IPC-6012
Hi Vladimir,
What you have here is a lifted pad. I think that that is rejectable to 6012.
There appears to be an adiquate wrap of copper.
Best regards,
Paul Reid
________________________________
From: TechNet on behalf of Vladimir Igoshev. PhD
Sent: Wed 13/03/2013 5:18 PM
To: [log in to unmask]
Subject: [TN] IPC-6012
I have a question for boards gurus,
We run a set of tests to assess the workmanship of a PWB. The board had vias-in-pad (in essence PTHs overplated with Cu pads) under a BGA.
After a thermal stress the pads were partially flitted due to cracked laminated underneath them. To me it's a recipe for disaster (like pad
cratering after assembly). However, I saw nothing about it in
IPC-6012. Did I just miss it?
I'd really appreciate any contractive comments.
--
Best regards,
Vladimir Igoshev. PhD mailto:[log in to unmask]
SENTEC Testing Laboratory Inc.
11 Canadian Road, Unit 7.
Scarborough, ON M1R 5G1
Tel: (416) 899-1882
Fax: (905) 882-8812
www.sentec.ca
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|