Not in a controlled manner, it will get some coating from the angled
spray of the large surface.
(unless Parylene)
regards,
Graham Collins
Senior Process Engineer
Sunsel Systems
(902) 444-7867 ext 211
On 3/26/2013 12:42 PM, Douglas Pauls wrote:
> OK, the conformal coat question of the day:
>
> Do you conformally coat the edges of a printed circuit assembly? Why or
> why not?
>
> OK, that is two questions, or perhaps a half fractional question.....
>
> Doug Pauls
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________