You may wish to examine the flux percentage level in your wire solder. Usually runs at .8%, 1.2%, or 3% or something similar. If you are using 3% flux content, you will get more spattering. To determine the level of spattering, there is a test for this in IPC-TM-650.

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Ioan Tempea
Sent: Friday, February 08, 2013 1:29 PM
To: [log in to unmask]
Subject: [TN] Anti-splashing solder wire

Dear Technos,

What do you think about this? Sounds pompous, but I wonder if this existed...

We noticed many solder balls and splashes on a particular board, after manual soldering or repairs/touch-ups and I wonder if there would be a particular brand/model of solder wire which is less splash prone.

Thanks,

Ioan Tempea, ing.
Ingénieur principal de fabrication / Senior Manufacturing Engineer [signature002]<http://www.digico.cc/>

950 RUE BERGAR, LAVAL, QC, H7L 5A1<http://g.co/maps/2gh3f>
T+ 1 (450) 967-7100, EXT244
------------------------------------------------------------------------
  [signature001] <http://www.facebook.com/pages/Digico/277076778479>
------------------------------------------------------------------------
Lauréat Dunamis 2012<http://digico.cc/dunamis-2012/>
Entreprise manufacturière / Gestion du capital humain


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________