Dear Technos,

Got a tough one now!

We apply 1B31S with our Asymtek selective coating machine and there are 8 difficult connectors, where coating infiltrates inside and on the pins. What can I do to prevent this from happening?

We've tried to manually lay down some non-diluted coating around the parts. Kinda stops infiltration, but it's long and manual, many bubbles in the coating layer. We've tried gel coating around the connectors, but it cracks, leaving a lot of room for infiltration. Not to mention that the closer the selective nozzle gets to connectors, the more prone we are to finding spots on the pins (it seems impossible to completely eliminate satellites when the nozzle head changes direction or at start-stop).

Ideally we would find something that can be dispensed around those connectors in a controlled manner (even if we need to buy some sort of table top dispensing machine) so that we seal them, followed by selective dispensing on the rest of the board. We really want zero or minimal manual work, as it's not repeatable.

Any suggestions?

Thanks,

Ioan Tempea, ing.
Ingénieur principal de fabrication / Senior Manufacturing Engineer
[signature002]<http://www.digico.cc/>

950 RUE BERGAR, LAVAL, QC, H7L 5A1<http://g.co/maps/2gh3f>
T+ 1 (450) 967-7100, EXT244
------------------------------------------------------------------------
  [signature001] <http://www.facebook.com/pages/Digico/277076778479>
------------------------------------------------------------------------
Lauréat Dunamis 2012<http://digico.cc/dunamis-2012/>
Entreprise manufacturière / Gestion du capital humain


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________