Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Tue, 15 Jan 2013 09:43:37 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Is there any guidance in IPC publications about acceptable clearance
between components and mounting hardware? I can't find anything, but one of
our designs has a QFP144 near a screw (more than 100 mils), and someone is
wondering if it will be a problem.
Here is a partial picture:
http://frontdoor.biz/PCBportal/QFP144mtg.gif
There's also a crystal to the left of the mounting hole, and they were
wondering about that one, too. Should I be worried?
(always feelin' like "the new guy")
Jack
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|