Hi Inge

Thanks for the advice

Regards,
Angel

________________________________
From: Inge Hernefjord [mailto:[log in to unmask]]
Sent: Wednesday, December 05, 2012 2:04 PM
To: TechNet E-Mail Forum; Reyes, Angel LAM2 4429
Subject: Re: [TN] PCB assembly potted evaluation validation

Angel (first time I write  to an angel), when I was in the SMT business we mainly used IPC-A-600 , Acceptability of printed boards.  If it is a military High Voltage unit, you may need to add MIL-STD-883 /
*  3006.1 High level output voltage
If your customer is european, there are corresponding NF, DIN, BN etc

Inge
On 5 December 2012 21:42, Reyes, Angel LAM2 4429 <[log in to unmask]<mailto:[log in to unmask]>> wrote:
Hello TechNetters;

Does any one know or recommend any test standard to validate performance and reliability for PCB (FR4 0.031" THCK) double side SMT assemblies potted with epoxy or polyurethane

Regards,
Angel

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]>
______________________________________________________________________


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________