Hi all,
I need to design a polymer lid that gets glued on top of a square PCB.
The lid will be 0.66" x 0.66" by 0.20" (maybe 0.025" wall thickness) with a
flat top so I can have the company logo and part number printed on it.
The PCB itself is a system that gets soldered to a main board by way of
castellated holes.
My question is, what lid material should I use since this unit must go
through a reflow over?
I assume a vacuum formed CPVC lid would melt right?
The unit is somewhat similar in mechanical characteristics to a Linx module
like the TXM-xxx-es
https://www.linxtechnologies.com/resources/data-guides/txm-xxx-es.pdf
Thanks
Ken
_____________________________________
Kenneth J. Wood
Saturn PCB Design, Inc.
[log in to unmask]
www.saturnpcb.com
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________