After reviewing the bare board packaging and shipping recommendations in
IPC-1601 (which addresses getting the boards from the fabricator to the
assembler) the question came up about the humidity levels INSIDE the
fabricator DURING the fabrication.
Does IPC address that? Maybe I haven't had enough coffee today, but a
search for "moisture" or "humidity" in IPC-6012, IPC-A-600, etc didn't
reveal very much useful info. Are we trying to control that? Or just the
moisture level in the finished product?
just point me in the right direction, please...?
Jack
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________