Patrick,
Yes they have different juices for different materials.
As I indicated to Mark, don't expect them to come out in absolutely pristine
condition... or maybe I have always been in too much of a hurry to fully
optimize the process. Frequently, only had the one part to play with, so a
bit difficult to optimize
Steve Creswick
Sr Associate - Balanced Enterprise Solutions
http://www.linkedin.com/in/stevencreswick
616 834 1883
-----Original Message-----
From: Goodyear, Patrick [mailto:[log in to unmask]]
Sent: Thursday, October 11, 2012 11:52 AM
To: [log in to unmask]; 'Steven Creswick'
Subject: RE: [TN] Glob Top removal
Fantastic, never knew stuff like this existed. We have old potted
comparators 60's vintage that we need to reverse engineer, someone was
going to have to spend hours grubbing out the case to see what exactly was
inside. Looks like it might be an easier solution.
Pat Goodyear
Control Tech PG&E
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steven Creswick
Sent: Thursday, October 11, 2012 2:38 AM
To: [log in to unmask]
Subject: Re: [TN] Glob Top removal
Mark,
I used to use a material called Decap from Dynaloy - based out of
Indianapolis, IN. Here is their web site.
http://www.dynaloy.com/dynaloy-chemical-solutions-products/specialty-chemist
ries/epoxy-products.html
The Decap will work for many glob tops, but you must keep an eye on
temperature. Some are removed better with warm temps, others with hot
temps. You really have to test for yourself unless you know the composition
of the glob top material. DO NOT use without a vented hood. The stuff
reeks something terrible. Make you wish you lived next to a pig barn!
What I would do is suspend the part in the solution and periodically shake
it around a bit to dislodge the silica particles from the 'glob', thereby
exposing new epoxy to the chemical. It is not perfect, but is far less
hazardous than fuming nitric!
They also have materials for Urethane CC removal, but not necessarily
localized removal...
Steve Creswick
Sr Associate - Balanced Enterprise Solutions
http://www.linkedin.com/in/stevencreswick
616 834 1883
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Woolley, Mark D. (Mark)
Sent: Wednesday, October 10, 2012 11:59 PM
To: [log in to unmask]
Subject: [TN] Glob Top removal
Does anyone know of a way to remove the epoxy that is used to cover CoB ICs,
while maintaining the integrity of the PWB-CoB Assembly afterwards?
I have tried hot Nitric Acid, which does remove the epoxy nicely, but also
removed the copper on the PWB and swelled during the decap process and
ruptured the bondwires. I believe Red Fuming Nitric would also swell the
epoxy lifting the bondwires. Most aggressive solvents don't remove epoxies
well. So I am pout of ideas at present.
Thanks,
mark
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
PG&E is committed to protecting our customers' privacy.
To learn more, please visit
http://www.pge.com/about/company/privacy/customer/
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
