Hi Pete,
Beside checking the impurities issue, I am recommending to check also the
soldering results as well such as dull / cold appearance etc.
In general I am not recommending to save money in such suggestions.
Good luck
Reuven

On Fri, Sep 14, 2012 at 4:56 PM, Pete <[log in to unmask]> wrote:

> My understanding is that they will do the recycling themselves, on site.
>  They said the recycling would be mechanical, not chemical, so maybe it is
> just squeezing out the droww.  They also said it was an effort to be
> environmentally conscious, but they are in China, so I'd think it's really
> cost.
>
> We are among their smaller customers, so I can't make a lot of demands.
>  They asked if we would accept boards made with recycled solder.  I suppose
> the best I can do is reply with a list of concerns and ask for test results.
>
> Thanks!
>
> Pete
>



-- 

Best Regards,

*Reuven Rokah*

Mobile: 972-52-6012018
Tel:        972-3-9360688
Fax:          076-5100674
 <http://www.rokah-technologies.com/>[log in to unmask]
[log in to unmask]
www.rokah-technologies.com

**
This e-mail message is intended for the recipient only and contains
information which is CONFIDENTIAL and which may be proprietary of Rokah
Technologies. If you have received this transmission in error, please
inform me by e-mail, phone or fax, and then please delete all of the
original files and all other copies exist.


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________