Stephen,
My cable has tin at the end and my board:
MCPCB, 1,6mm , HASL my pad size is 4x4mm.
Thank you

Juliano Ribeiro



De: stephen gregory [mailto:[log in to unmask]]
Enviada em: quinta-feira, 2 de agosto de 2012 10:24
Para: TechNet E-Mail Forum; Juliano Ribeiro
Assunto: Re: [TN] MCPCB - Soldering

Hi Juliano,

Hard to answer because we don't know what kind of cable you're trying to solder into the board. We also don't know what kind of board it is (how thick, etc.).

Do you tin the wire at the end of the cable first?

Steve Gregory
________________________________
From: Juliano Ribeiro <[log in to unmask]>
To: [log in to unmask]
Sent: Thu, August 2, 2012 8:57:40 AM
Subject: [TN] MCPCB - Soldering

Hello,
We need to do manual solder in MCPCB - Cable in the MCPCB. But the tip hot is higher and the solder nonwetting in the MCPCB just in the cable.
1 - We need change our manual solder process? Special tips or soldering station we need to buy? What the correct temperature to solder in this board?
2 - In the SMT process (LED Soldering), are what caution during reflow?

Thank you


Juliano Ribeiro
Coordenador de Produção - Placas Eletrônicas
Elo Sistemas Eletrônicos S.A.

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]>
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________