Change to a different laser...
Paul
Paul Edwards
Process/Quality Engineering
Surface Art Engineering
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent: Tuesday, June 19, 2012 1:33 PM
To: [log in to unmask]
Subject: [TN] Type 3 flex burnt during laser cutting
Need guideline for acceptance.
We have a Type 3 flex that requires laser cutting. (CO2 laser)
Sometimes (very rare)..we see laser burn on the flex.
What is the acceptance criteria. Looked in IPC-600 and 6013. Does not address the laser cutting/burn situation.
OR if you have seen this and how was it handled.
Rashesh
Accurate Engg Inc.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________