Subject: | |
From: | |
Reply To: | |
Date: | Fri, 29 Jun 2012 10:33:25 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
yep. ENIG can be fine in pressfit app.
Read the connector mfg spec carefully and spec the pressfit holes separately.
1st order effect is getting the correct drilled hole size before plating.
2nd order concern (a close second), ensure copper
hole wall minimum plating. Keep from overplating the hole wall.
3rd order concern, min hole size. If hole wall is
overplated insertion forces will spike and your
press with hang up or pins will Z into the board surface.
At 12:38 AM 6/29/2012, Frank Kriesch wrote:
>Victor, it works. It's a matter of dimensioning
>the drill holes. Frank Von: Victor Hernandez
><[log in to unmask]>
>An: <[log in to unmask]> Datum: 28.06.2012
>20:13 Betreff: [TN] Press Fit Pins on
>ENIG raw board Gesendet von: TechNet
><[log in to unmask]> Fellow TechNetters: Are the
>pins in connector designated for Press Fit Pins
>gold plated for insertion into an ENIG raw
>board. What is the acceptable process. If
>both interfaces are gold plated with a thin
>layer of gold, the thin layer of gold would be
>wiped off during the insertion process. Then
>you would have a nickel to nickel mating
>surface. Does this sound correct. The
>interface should form a tight air seal. Victor,
>______________________________________________________________________
>This email has been scanned by the Symantec
>Email Security.cloud service. For more
>information please contact helpdesk at x2960 or
>[log in to unmask]
>______________________________________________________________________
>. Der Inhalt dieser E-Mail ist für den Absender
>rechtlich nicht verbindlich. Informieren Sie uns
>bitte, wenn Sie diese E-Mail fälschlicherweise
>erhalten haben (Fax: +49-7551-891-4001). Bitte
>löschen Sie in diesem Fall die Nachricht. Jede
>Form der weiteren Benutzung ist untersagt. . The
>content of this e-mail is not legally binding
>upon the sender. If this e-mail was transmitted
>to you by error, then please inform us
>accordingly (Fax: +49-7551-891-4001). In such
>case you are requested to erase the message. Any
>use of such e-mail message is strictly
>prohibited.
>______________________________________________________________________
>This email has been scanned by the Symantec
>Email Security.cloud service. For more
>information please contact helpdesk at x2960 or
>[log in to unmask]
>______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|