Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Fri, 29 Jun 2012 09:04:43 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Sometimes there is a requirement to remove the marking on a chip after assembly or even before assembly.
What sort of issues come from this activity?
Is there a company that is expert at doing this that could contract to do this?
If we did it in house, what equipment and expertise would we need?
Where should I look to for advice?
Bill Brooks | Datron World Communications, Inc.
PCB Designer/Engineer | Office: 760-602-7004| Fax: 760-597-3777 | [log in to unmask]
3055 Enterprise Court, Vista, CA 92081 | www.dtwc.com
Performance You Require. Value You ExpectTM
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|