Hi all,

Take a look at the photo's at the below links (one shows picture of a new cap).  I'm trying to figure out why the end terminations of a tantalum capacitor (C37 and C38) are coming out of the reflow discolored.  In our process, the middle boards of our panel have the discolored terminations.  The boards on the outside of the panel are all fine.  I think it's a heat related issue, but I don't know why only the middle boards are affected.  All the solder joints are looking fine as well (even on the discolored terminations).

Any thoughts as to what might be happening?  In your opinion, would your reject these?

http://stevezeva.homestead.com/Discolored_Tant.jpg

http://stevezeva.homestead.com/New_Tant.jpg

Jim West







Attention:  
The information contained in this email message may be privileged and is
confidential information intended only for the use of the recipient, or any
employee or agent responsible to deliver it to the intended recipient. Any
unauthorized use, distribution or copying of this information is strictly
prohibited and may be unlawful. 
  
If you have received this communication in error, please notify the sender
immediately and destroy the original message and all attachments from your
electronic files.

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________