Sender: |
|
X-To: |
|
Date: |
Thu, 29 Mar 2012 12:21:09 -0700 |
Reply-To: |
|
Subject: |
|
From: |
|
Message-ID: |
|
In-Reply-To: |
|
Content-Type: |
text/plain; charset="US-ASCII" |
MIME-Version: |
1.0 |
Parts/Attachments: |
|
|
When I've run into that problem is always turns out that I think the water
is off and there is a trickle that pulls off enough heat to prevent solder
melt. Did they use another type of solder? Some smart guys use Silver
solder and map gas or acetylene.
Chuck
Charles W. Brummer | 3M Manufacturing Engineer
3M Electronic Solutions Division
3M Canoga Park, 8357 Canoga Ave. | Canoga Park, CA 91304
Office: 818 734 4930
[log in to unmask] | www.3M.com
This message (including any attachments) may contain material, non-public
information or proprietary information and is for the intended recipients
only. If you are not the intended recipient, you should notify the sender
and delete this message. Any disclosure, copying, or use of this
information is strictly prohibited and may subject you to legal liability.
From:
Blair Hogg <[log in to unmask]>
To:
<[log in to unmask]>
Date:
03/29/2012 10:20 AM
Subject:
[TN] NTC- unmeltable solder
Sent by:
TechNet <[log in to unmask]>
The recent discussions on rework issues reminded me of a while back where
I needed to repair a leaky water pipe in my home. Took a chunk of the
ceiling out, got out the plumbers torch, drained the pipes and started to
heat. No matter what I did to the joint that was leaking I could not get
anything to melt. Had to cut the pipe on either side of the elbow joint
and patch in a new section. Even afer I took it out I could not get it
apart. Not sure what happened to the solder but something changed it to
make it unmeltable.
Blair
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|