Hi Howard - welcome back! One thing to consider is that smaller ovens
(aka any oven with less than 7 zones per my definition) will have thermal
limits in relationship to the printed wiring assemblies. You may have some
assemblies that due to either the component density or pwb construction
that demand more thermal energy than a small oven is capable of
delivering. Per your description, it sounds like you may have found that
limit on some designs. As a standard rule of thumb, we always look at
ovens with a minimum of 9 heating zones due to the thermal demands of the
assemblies we process.
Dave Hillman
Rockwell Collins
[log in to unmask]
"Watson, Howard A" <[log in to unmask]>
Sent by: TechNet <[log in to unmask]>
02/15/2012 09:44 AM
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
"Watson, Howard A" <[log in to unmask]>
To
<[log in to unmask]>
cc
Subject
[TN] IR Reflow Oven capability
Hello all,
Wow, after an 8 year hiatus from the electronics industry, and the
Technet, I am surprised to see so many familiar names still active on the
Technet. I see this as a testament to your wisdom and staying power,
something I didn't have!
In my new job, in a very small shop of R&D quantity, I see that we have a
very small IR reflow oven that is seldom used (most of our boards are
entirely hand soldered or contracted out). The oven is a ~15 year old
bench top oven with a heating tunnel that is 3 feet long - 4 heat zones.
The reports I hear are of "hit-or-miss" quality output, which might not
necessarily be the oven and could be the process. Our boards can be
complex, multi-layer and with some large QFPs, big ground planes, etc. My
question is: does anyone have direct experience to share regarding these
small bench top IR reflow ovens, and did/do you have a positive
experience? For the record, the oven is a DIMA SMT Systems SMRO-0252. We
use 63/37 solder, RMA flux. We do profile the boards, but since the
datapaq has not been calibrated in 10+ years, I look at these profiles
with some suspicion. Your feedback will help my decision process to keep
the oven and work on the process, or work on getting a new oven. As
always, I appreciate your insight!
Howard Watson
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|