Did your Feb house provide with you "can do, can not do" check list? Or you finish design and send over to X number of Feb and wait for "no bid"? 94% I am really take it a back - wow.
--------------------------
Sent using BlackBerry
----- Original Message -----
From: Mark Larson [mailto:[log in to unmask]]
Sent: Wednesday, December 14, 2011 04:50 PM
To: [log in to unmask] <[log in to unmask]>
Subject: Re: [TN] BGA SMD vs NSMD
no matter what type of manufacturing and fabrication you are talking about, the end result is never exactly as designed, there is a tolerance involved, unless of course you want to pay an exorbitant amount to use only the ones that are exactly as designed and throw away the other 94%.
the reason you supply 1:1 of the soldermask is that each fabricator has different equipment and processes than the next
they will "grow" the data such that you will not have solder mask on your smd pads, and 1 mil max overlap on your thru hole lands
they have to allow for mis-registration between the solder mask pattern and the lands, you can figure out what this mis-registration is by looking at their technology roadmap, typically, the tighter the tolerance, the more you pay because the equipment to do it is newer and more expensive (if you have very fine pitch devices, there is no choice but to use it)
if you always use the same fabricator (such as in-house fabrication) then they may want you to adjust the s/m pad sizes up front, but to do so without this requirement is to bring pain onto yourself, your fabricator, and nearly everyone else involved
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------------------------
This transmission (including any attachments) may contain confidential information, privileged material (including material protected by the solicitor-client or other applicable privileges), or constitute non-public information. Any use of this information by anyone other than the intended recipient is prohibited. If you have received this transmission in error, please immediately reply to the sender and delete this information from your system. Use, dissemination, distribution, or reproduction of this transmission by unintended recipients is not authorized and may be unlawful.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
