Sue,

It depends what you have stated in the contract between the organization and the customer.
In this circumstances they might need to approve the repair procedure or the repair is not allowed as this if defect condition for class 3 as per 610D.

BTW, I would as well use a wire connected to the component termination and then soldered to the point of the same potential as the via-pad underneath damaged/removed pad.

From the IPC-7721A point of view  there is no procedure that may clearly reflect your condition.
Maybe there is something in B rev but I do not have the latest one to determine the above.
As per 610D lifting of a land if there is via in the land is a defect condition.

Rgds
Andy
------Original Message------
From: Sue Powers-Hartman
Sender: TechNet
To: [log in to unmask]
ReplyTo: TechNet E-Mail Forum
ReplyTo: Sue Powers-Hartman
Subject: Re: [TN] Pad repair
Sent: 8 Sep 2011 21:50

Bob,  thanks for the reply.  I am under the impression that the customer doesn't feel that there is an acceptable fix, but will present this solution to them just the same.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

Sent using BlackBerry®

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________




---------------------------------------------------

Technet Mail List provided as a service by IPC using LISTSERV 16.0

To unsubscribe, send a message to [log in to unmask] with following text in

the BODY (NOT the subject field): SIGNOFF Technet

To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)

To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest

Search the archives of previous posts at: http://listserv.ipc.org/archives

For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815

-----------------------------------------------------