Subject: | |
From: | |
Reply To: | |
Date: | Thu, 1 Sep 2011 07:57:11 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dear Mark
As we are a CEM we get every conceivable method.
The only method that I have seen give a difficulty is where open vias go
to a solderable plane on the bottom. This seems to introduce additional
forces into the tug of war between the top and bottom faces and swings
the tug in favour of the solder being stolen by the bottom side.
In the past we have done the arithmetic to ensure that enough paste is
applied to fill the vias.
Regards
Rex
Rex Waygood
Technical Manager
Hansatech EMS provides value manufacturing through engineering and
quality
Hansatech EMS Limited
Benson Road
Nuffield Industrial Estate
Poole
Dorset
BH17 0RY
+44 (0)1202 338200
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Mark Larson
Sent: 31 August 2011 20:52
To: [log in to unmask]
Subject: [TN] QFN with solder slug
I am curious how others are handling these parts for soldering. Do you
leave the thermal vias in the slug covered or uncovered with solder
mask? Do you fill with anything? What size hole on a 62 mil board? Tie
to all GND planes or just the back side? Thermal relief the via or bury
it in the plane?
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0 To
unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET
Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the
posts: send e-mail to [log in to unmask]: SET Technet Digest Search the
archives of previous posts at: http://listserv.ipc.org/archives For
additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
______________________________________________________________________
This email has been scanned by the MessageLabs Email
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|