Be sure all of the manufacturing equipment can handle the panel size. Be sure to talk to the panel fabricator to maximize the number of panels obtained from a single flat, to avoid excessive waste (cost driver).

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Jean-Francois Bissonnette
Sent: Thursday, April 28, 2011 4:29 PM
To: [log in to unmask]
Subject: [TN] Panel manufacturability

Hi all,

 

Is there any rules that can guide me for calculating a good panel size.  We
have a board 4x5.5.  Considering a paste mask with 22"x22", I'm thinking
that a 5x1 panel would be OK. but is there anything that I'm missing?

 

Thanks!

 

Jean-François Bissonnette

DEPRO Électronique Inc

755, Curé-Boivin suite 101

Boisbriand, Québec

Canada     J7G 2J2

Ph. 450.430.6251  Poste/Ext: 109

Fax: 450.430.6251

 


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------