Subject: | |
From: | |
Reply To: | |
Date: | Wed, 25 May 2011 07:55:57 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Folks,
Thank you to all who shared their experience/knowledge with the above stated topic.
Victor,
From: Reuven Rokah [mailto:[log in to unmask]]
Sent: Wednesday, May 25, 2011 7:20 AM
To: TechNet E-Mail Forum; Hernandez, Victor G
Subject: Re: [TN] Pres Fit Pin Technology guideline
I think HASL finish is more tolerable than OSP finish in tolerances.
The additional of Sn/Pb or SAC coating on the Cu plating give grease effect and more contact area at the Press fit pins corners.
Reuven
On Tue, May 24, 2011 at 6:05 PM, Victor Hernandez <[log in to unmask]<mailto:[log in to unmask]>> wrote:
Fellow TechNetters:
What is the consensus on the use of Press Fit Pins insertion into a final surface board finish of OSP or HASL? Is there a difference in the term Press Fit Pins or Compliance Pins?
Victor,
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]<mailto:[log in to unmask]>
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask]<mailto:[log in to unmask]> with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask]<mailto:[log in to unmask]> or 847-615-7100 ext.2815
-----------------------------------------------------
--
Best Regards,
Reuven Rokah
Mobile: 972-52-60-120-18
Tele-fax: 97239360688
<http://www.rokah-technologies.com/>[log in to unmask]
<mailto:[log in to unmask]>[log in to unmask]<mailto:[log in to unmask]>
www.rokah-technologies.com<http://www.rokah-technologies.com/>
[http://royiro.weebly.com/uploads/6/3/6/9/6369812/4511319.jpg?303]
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|