How are 0.125" PCB's done on PnP?  We have a 0.125" board, forget the
dimensions but it's probably 10"x18".  For the application I suspect
we'd very much prefer the nice milled edges on the PCB edges-rather than
a V-score or worse, mouse-bitten edges-but as I think about it, I'm not
sure how these thicker boards are handled even for smaller boards.
Would the normal case be, for thick boards, for the boards to be mill
route separated; and then some sort of jig/framework used so that the
board can go down a PnP setup?

 

Shawn Upton, KB1CKT

Test Engineer

Allegro MicroSystems, Inc

[log in to unmask]

603.626.2429/fax: 603.641.5336

 


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------