wubosz，您好！
   I am not in the office during Jan.20 to Feb.8th, please call my cell phone at 13459205246 if any urgency.


在 2011-01-25 21:51:08 您写道：
>您好！
>      首先看一下断口位置，然后才能找到解决办法。
>
>--
>
>
>吴波
>
>[log in to unmask]
>
>13602585865
>
>
>在 2011-01-25 16:57:05，"郑立鹤" <[log in to unmask]> 写道：
>
>
>各位好！
>
>     我们有一款端子台输出的产品遭客户投诉端子台脱焊，如图
>
>   
>
>    据以往的经验，我们认为可能是两个原因造成的：
>
>1、  端子台引脚焊盘设计过小；2、使用时扭力过大。
>
>请问大家所在的公司对此类问题没有相应的规定。
>
>讨论一下！
>
>谢谢！！！
>
>电子工程：郑立鹤
>
>佛山市伊戈尔电业制造股份有限公司
>
>佛山市南海区简平路桂城科技园A3号
>
>MP：18666577208      zip code:528200
>
>Tel：0757-86256771
>
>E-mail：[log in to unmask]
>
>Website：www.eaglerise.com
>
> 
>
>
>______________________________________________________________________
>This email has been scanned by the MessageLabs Email Security System.
>For more information please contact helpdesk at x2960 [log in to unmask]
>______________________________________________________________________
>
>______________________________________________________________________
>This email has been scanned by the MessageLabs Email Security System.
>For more information please contact helpdesk at x2960 or [log in to unmask] 
>______________________________________________________________________

                    致
礼！

            Angela
            [log in to unmask]

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________