Season Greetings All,
In the opinion of all the experts out there, are there any issues I need 
to be aware of in using a No-Clean flux while using a wave pallet?
I am trying to wave solder some through hole pins on a SMT assembly 
(populated 2 sides).
Are there flux spray heads that can limit the flux to the exposed pins in 
the wave pallet?
How often do the wave pallets need to be cleaned between each run?
I would be most interested in any stories of disaster or success on this 
issue.

Thank you in advance and Best wishes to all for a prosperous New Year.


Tom Burek, CID+
Ametek/VIS



______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/ContentPage.aspx?Pageid=E-mail-Forums for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------