I was on the shop floor and noticed deflection in the 8x8 inch panel that
was being populated.  Would the deflection in the middle of the panel cause
components to sit higher on the paste and thus have a slightly higher solder
joint height than components on boards along the rails?       Thanks in
advance

 

Dale L. Hart

Universal Technology Corporation (UTC)

Failure Analysis

1270 North Fairfield Road

Dayton, Ohio  45432-2600

(937) 656-9165

Fax (937) 656-4600

Email:  <mailto:[log in to unmask]> [log in to unmask]

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------