Subject: | |
From: | |
Reply To: | |
Date: | Fri, 26 Mar 2010 08:02:45 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
The requirements of J-STD-002 permit this problem. Solder performance near
the package body is not required. It is a problem.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bev Christian
Sent: Thursday, March 25, 2010 9:08 PM
To: [log in to unmask]
Subject: [TN] Need some opinions
Technetters,
It seems that more and more component suppliers are not plating their leads
all the way up to the component body. In fact some are getting downright
skimpy and only plating to the bottom bend, never mind the upper one. If you
put down a lot of solder paste you end up with a bulbous joint, a negative
wetting angle and a stress concentration point. If you put down less paste
and have a co-planarity issue, then you have the potential for opens. The
other option of course is getting the supplier to plate higher up the leads.
Question: would you consider the condition of the formation of the negative
wetting angles a failure during process qualification?
Bev
RIM
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|