Technetters:
We are working on a project where we have to mill down 0.005" on each side of a populated FR-4 board which is 0.062" in thickness making the nominal thickness 0.052" +/- 0.002".
The question for you mech-e's out there is :
"How will the mechanical properties of the board change with 0.010" being shved off of the thickness?"
<The thickness is reduced by this amount near a mounting hole>
Thanks
Bob Wettermann
BEST Inc
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------