Hi Gang:
My customer is having a problem in wave soldering. The board has surface
mount and through hole components on top side and there are some test
points on the bottom side. While passing through wave solder, the holes are
filling nicely but solder is not being coated on some of the test points. Some
test points are in the ground plane (solder mask defined) and the others is
isolated but sorrounded by ground plane. I can cover those pads using solder
iron without any problems.
When performing the similar process at some other assembly house in wave
solder, I noticed the same problem. I played with higher pre-heat
temperatures, slower and faster speed but same result. Any thought on this
issue?
Thanks,
Amarjot
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------