Allen,

You will be looking for a shop that can punch the holes as opposed to
routing them.

John Parsons
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Allen Maddox
Sent: Friday, December 11, 2009 8:28 AM
To: [log in to unmask]
Subject: [TN] Looking for Board House to help with specail boards

We have been given a board to manufacture. I’m looking for a raw PCB
Manufacturer that can do square cuts. There are two rectangle cut outs
(.120" x .040"). These are right angle cut outs with pads on both sides and
they need to be plated through. There is another cut out with inside right
angles. The left and the right hand cut outs will have copper to the edge
and need to plated through while the top and the bottom will have not copper
and will not be plated.
A few vendors have said that you can not have "square holes". But I have a
board in my hand from the previous version that has all square right angle
cuts on the board outline as well as a few square holes. This will probably
become a high volume product.
Can anyone recomend a vendor who could make these?
I can send more information if anyone is interested.
 
Allen Maddox, CID+

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------