Greetings!
We have an assembly where the board edge was ripped badly during
depanelization.
I searched through the Assembly Acceptability IPC-A-610 and didn't find
much, but
in the bare board IPC-A-600 section 2.1, I can see plainly that ours is
rejectable.
The question is, can I use the BARE BOARD spec to reject an ASSEMBLY?
Or is there anything in the assembly specs that covers depanelization
damage?
thanks,
Jack
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------