This is not about whose fault it is, but where can I find criteria to accept/reject.....

Constantino J. González, ACME, INC. - GALUSAMEX REPAIR Co.
President / Consultant Engineer - Official IPC MASTER INSTRUCTOR - IPC-A-610 Committee Chairman
USA Cell Phone: 605-381-5963 - Mexico Cell Phone: 55-2709 - 6392 - [log in to unmask] or [log in to unmask] 
Skype - acmeinc_cjg  
Does your Company need Rework, Repair or Inspection of Electronic Assemblies Services. 
Do you have too much Rework, Scrap or Rejects from your Customer…..Call us, We can help!
GALUSAMEX REPAIR Co.
   
Please consider the environment before printing this email
 
This email communication may contain CONFIDENTIAL INFORMATION WHICH ALSO MAY BE LEGALLY PRIVILEGED and is intended only for the use of the intended recipients identified above.  If you are not the intended recipient of this communication, you are hereby notified that any unauthorized review, use, dissemination, distribution, downloading, or copying of this communication is strictly prohibited.  If you have received this communication in error, please immediately notify us by reply email, delete the communication and destroy all copies.
  



-----Original Message-----
From: IPC-600-6012 [mailto:[log in to unmask]] On Behalf Of Jose A Rios
Sent: Monday, December 14, 2009 10:37 AM
To: [log in to unmask]
Subject: Re: [IPC-600-6012] Acceptability of Shredded Board Edge

i'd say yes, if you can prove to the pwb supplier that its an incoming 
defect, not created during assembly.

Joey Rios
PWB & Process Quality Eng'r
Endicott Interconnect Technologies
1093 Clark St.
Endicott, NY 13760
Office: 607-755-5896



Jack Olson <[log in to unmask]> 
Sent by: IPC-600-6012 <[log in to unmask]>
12/14/2009 11:51 AM
Please respond to
"(Combined Forum of D-33a and 7-31a Subcommittees)" <[log in to unmask]>


To
[log in to unmask]
cc

Subject
[IPC-600-6012] Acceptability of Shredded Board Edge






Greetings!

We have an assembly where the board edge was ripped badly during
depanelization.

I searched through the Assembly Acceptability IPC-A-610 and didn't find
much, but in the bare board IPC-A-600 section 2.1, I can see plainly
that ours is rejectable.

The question is, can I use the BARE BOARD spec to reject an ASSEMBLY?
Or is there anything in the assembly specs that covers depanelization
damage?

thanks,
Jack