Subject: | |
From: | |
Reply To: | |
Date: | Fri, 6 Nov 2009 19:17:31 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hey there,
I've a q about via fill for LGA, small ones, package 5x5 millimeters and 8
I/Os, teflon one layer on thick brass back. Heat transfer vias 0.5 mm. How
do you fill them before mounting the LGAs? Halfways, even or overfilled? If
the solder volume is too meagre, there will not be a good SJ against the LGA
heat sink (under side), if you have too much solder, you may get
overbridging. There are five vias for the contact with the heat sink, four
vias in a square and one in the middle. We solder same size of packages with
J-leads on the same board, and they become perfect, but the LGAs get varying
result.
/Inge
PS. I regret the deplorable incident in Austin. Bad, very bad in many
aspects, both socially and politically. The human nature is really
unpredictable.
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|