 
| Subject: | |
| From: | |
| Reply To: | |
| Date: | Wed, 30 Sep 2009 11:05:02 -0700 |
| Content-Type: | text/plain |
| Parts/Attachments: |
|
|
It's best to verify coating in a very well darkened room. When coatings are verified at a workbench with ambient white light all around you'll find that the fluorescence of the coating will be overcome by the reflection from shiny metal cans and other reflective parts, making them appear to be uncoated. Try looking at the boards in a dark room and see if there's a difference.
Gregg
-----Original Message-----
From: Hetal Shah [mailto:[log in to unmask]]
Sent: Wednesday, September 30, 2009 9:34 AM
To: [log in to unmask]
Subject: [TN] UV can't see on the board
Hello,
The silicone conformal coating (UV added) was applied on our board.
All parts are well covered from both angles and were inspected under a UV
light.
All I need to have is just a small explanation of why the UV cannot be see
on some particular parts.
Any insight into this matter would greatly be appreciated.
Hetal shah
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|
