TECHNET Archives

August 2009

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Hernefjord Ingemar <[log in to unmask]>
Reply To:
TechNet E-Mail Forum <[log in to unmask]>, Hernefjord Ingemar <[log in to unmask]>
Date:
Thu, 20 Aug 2009 09:01:59 +0200
Content-Type:
text/plain
Parts/Attachments:
text/plain (319 lines)
As Alma Cogan sings: Stupid, stupid..
Inge 

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Mike Buetow
Sent: torsdag 20 augusti 2009 02:58
To: [log in to unmask]
Subject: Re: [TN] NTC - Component bake out

 I am already contemplating which of my friends' phones I will first try that out on.

Hehehe

Mike

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bev Christian
Sent: Wednesday, August 19, 2009 8:53 PM
To: [log in to unmask]
Subject: Re: [TN] NTC - Component bake out

Just back from holiday in western Canada.

Apparently in some Scottish circles (well at least one) when you go to a friend's house for a party it is "fun" to try and swipe the homeowner's cell phone, take out the battery and put it in a microwave oven for a FEW seconds and then put it back together again. Bad things happen, especially if a person leaves it long enough.  Trust me when I say that all cell phone manufacturers can tell.
Bev
RIM
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Lee Whiteman
Sent: Wednesday, August 12, 2009 12:56 PM
To: [log in to unmask]
Subject: Re: [TN] NTC - Component bake out

Been there. Done that. Twice. Stick took a licking but it kept on running.

Now, would anyone dare to put a stick in a microwave?

Lee Whiteman, PMP
Senior Member Engineering Staff
L-3 Communications East
Telephone: (856) 338-3508
FAX: (856) 338-2906
E-Mail: [log in to unmask]
 

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Eric CHRISTISON
Sent: Wednesday, August 12, 2009 12:52 PM
To: [log in to unmask]
Subject: Re: [TN] NTC - Component bake out

Yep,

I have a memory stick that been through cttons and linens cycle at ~ 40 deg C about 4 times. No additional rinsing and air dried at room temperature over ~ 36 hours.

Still works fine.



David D. Hillman wrote:
> Hi  Mike - I have had the opportunity to run Doug Paul's memory stick
thru 
> the clothes washer/dryer cycle with soap  twice and Doug said it still

> works fine.  The critical parameter is as you described - a good rinse
and 
> bake/dry. 
>
> Also, Doug no longer loans me his memory stick.
>
> Dave
>
>
>
> Mike Fenner <[log in to unmask]>
> Sent by: TechNet <[log in to unmask]>
> 08/12/2009 11:29 AM
> Please respond to
> [log in to unmask]
>
>
> To
> [log in to unmask]
> cc
>
> Subject
> Re: [TN] Component bake out
>
>
>
>
>
>
> I did this with mine, as it was a Friday I borrowed some of the "DI"
water
> for our steam iron to rinse it over and then just left it in the
airing
> cupboard over the weekend. It worked fine Monday and still does!
>
> Regards
>  
>  
> Mike
> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of Eric Kalgren
> Sent: 12 August 2009 17:10
> To: [log in to unmask]
> Subject: [TN] Component bake out
>
> I dropped my flash drive in a puddle yesterday, it was completely 
> submerged for about 5 minutes.  I haven't applied any power to it yet,

> so I'm
pretty
> sure that it is not completely dead.  It is a Sandisk Cruzer - I
mention 
> the
> brand and type because it is probably easier to look it up and get an
idea
> of what it looks like than for me to attempt an adequate description.
>
>  
>
> My question:  How long and at what temperature should I bake this guy
to
> ensure that when I do plug it in, I don't let the magic smoke out of
the
> components inside the drive?
>
>  
>
> Next time it goes in my pants pocket, not my shirt pocket!
>
>  
>
> Thanks,
>
>  
>
> Eric Kalgren
>
> Electrical Engineer
>
> The Ferrite Co. Inc.
>
> 165 Ledge Street
>
> Nashua, NH 03060
>
> Phone 603-881-5234
>
> Fax 603-881-5406
>
>  
>
>
>
>  
>
> PRIVILEGED AND CONFIDENTIAL COMMUNICATION This E-mail is covered by 
> the Electronic Communications Privacy Act,
18 U.
> S. C." 2510-2521 and is legally privileged.  The information contained

> herein is confidential and is intended only for the use of the
individual 
> or
> entity named above.  If the reader of this message is not the intended

> recipient, you are hereby notified that any dissemination,
distribution or
> copying of this communication is strictly prohibited.  If you have 
> received this transmission in error, please immediately notify the 
> sender by telephone or via e-mail and delete the original transmission

> including
any
> attachments without reading or saving in any manner.
>
>  
>
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0 To 
> unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt 
> or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing 
> per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16
> for additional information, or contact Keach Sasamori at
[log in to unmask] or
> 847-615-7100 ext.2815
> -----------------------------------------------------
>
>
> ***This email, its content, and any files transmitted with it, are 
> intended solely for the addressee(s) and may be legally privileged
and/or 
> confidential. If you are not the intended recipient, please contact
the 
> sender by return and delete the material from any computer. Any
review, 
> retransmission, dissemination, or other use of, or taking of any
action in 
> reliance upon this information by persons or entities other than the 
> intended recipient is prohibited.
>
> Messages sent via this medium may be subjected to delays,
non-delivery, 
> and unauthorized alteration. This email has been prepared using 
> information believed by the author to be reliable and accurate, but
Indium 
> Corporation makes no warranty as to accuracy or completeness. Indium 
> Corporation does not accept responsibility for changes made to this
email 
> after is was sent. Any opinions or recommendations expressed herein
are 
> solely those of the author. They may be subject to change without
> notice.***
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0 To 
> unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt 
> or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing 
> per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 
> for additional information, or contact Keach Sasamori at
[log in to unmask] or 
> 847-615-7100 ext.2815
> -----------------------------------------------------
>
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0 To 
> unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt 
> or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
> -----------------------------------------------------
>
>   

--
Eric Christison Msc
Mechanical Engineer
Consumer & Micro group
Imaging Division

STMicroelectronics (R&D) Ltd
33 Pinkhill
Edinburgh EH12 7BF
United Kingdom

Tel:	+44 (0)131 336 6165
Fax:	+ 44 (0)131 336 6001

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the
posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

ATOM RSS1 RSS2