Awesome - now I can tell Doug that I am not the only one who has done
this!
Dave
Eric CHRISTISON <[log in to unmask]>
Sent by: TechNet <[log in to unmask]>
08/12/2009 11:52 AM
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
Eric CHRISTISON <[log in to unmask]>
To
[log in to unmask]
cc
Subject
Re: [TN] NTC - Component bake out
Yep,
I have a memory stick that been through cttons and linens cycle at ~ 40
deg C about 4 times. No additional rinsing and air dried at room
temperature over ~ 36 hours.
Still works fine.
David D. Hillman wrote:
> Hi Mike - I have had the opportunity to run Doug Paul's memory stick
thru
> the clothes washer/dryer cycle with soap twice and Doug said it still
> works fine. The critical parameter is as you described - a good rinse
and
> bake/dry.
>
> Also, Doug no longer loans me his memory stick.
>
> Dave
>
>
>
> Mike Fenner <[log in to unmask]>
> Sent by: TechNet <[log in to unmask]>
> 08/12/2009 11:29 AM
> Please respond to
> [log in to unmask]
>
>
> To
> [log in to unmask]
> cc
>
> Subject
> Re: [TN] Component bake out
>
>
>
>
>
>
> I did this with mine, as it was a Friday I borrowed some of the "DI"
water
> for our steam iron to rinse it over and then just left it in the airing
> cupboard over the weekend. It worked fine Monday and still does!
>
> Regards
>
>
> Mike
> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of Eric Kalgren
> Sent: 12 August 2009 17:10
> To: [log in to unmask]
> Subject: [TN] Component bake out
>
> I dropped my flash drive in a puddle yesterday, it was completely
> submerged
> for about 5 minutes. I haven't applied any power to it yet, so I'm
pretty
> sure that it is not completely dead. It is a Sandisk Cruzer - I mention
> the
> brand and type because it is probably easier to look it up and get an
idea
> of what it looks like than for me to attempt an adequate description.
>
>
>
> My question: How long and at what temperature should I bake this guy to
> ensure that when I do plug it in, I don't let the magic smoke out of the
> components inside the drive?
>
>
>
> Next time it goes in my pants pocket, not my shirt pocket!
>
>
>
> Thanks,
>
>
>
> Eric Kalgren
>
> Electrical Engineer
>
> The Ferrite Co. Inc.
>
> 165 Ledge Street
>
> Nashua, NH 03060
>
> Phone 603-881-5234
>
> Fax 603-881-5406
>
>
>
>
>
>
>
> PRIVILEGED AND CONFIDENTIAL COMMUNICATION
> This E-mail is covered by the Electronic Communications Privacy Act, 18
U.
> S. C." 2510-2521 and is legally privileged. The information contained
> herein is confidential and is intended only for the use of the
individual
> or
> entity named above. If the reader of this message is not the intended
> recipient, you are hereby notified that any dissemination, distribution
or
> copying of this communication is strictly prohibited. If you have
> received
> this transmission in error, please immediately notify the sender by
> telephone or via e-mail and delete the original transmission including
any
> attachments without reading or saving in any manner.
>
>
>
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0
> To unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16
> for additional information, or contact Keach Sasamori at [log in to unmask]
or
> 847-615-7100 ext.2815
> -----------------------------------------------------
>
>
> ***This email, its content, and any files transmitted with it, are
> intended solely for the addressee(s) and may be legally privileged
and/or
> confidential. If you are not the intended recipient, please contact the
> sender by return and delete the material from any computer. Any review,
> retransmission, dissemination, or other use of, or taking of any action
in
> reliance upon this information by persons or entities other than the
> intended recipient is prohibited.
>
> Messages sent via this medium may be subjected to delays, non-delivery,
> and unauthorized alteration. This email has been prepared using
> information believed by the author to be reliable and accurate, but
Indium
> Corporation makes no warranty as to accuracy or completeness. Indium
> Corporation does not accept responsibility for changes made to this
email
> after is was sent. Any opinions or recommendations expressed herein are
> solely those of the author. They may be subject to change without
> notice.***
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0
> To unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16
> for additional information, or contact Keach Sasamori at [log in to unmask]
or
> 847-615-7100 ext.2815
> -----------------------------------------------------
>
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0
> To unsubscribe, send a message to [log in to unmask] with following text
in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
> Search the archives of previous posts at:
http://listserv.ipc.org/archives
> Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
> -----------------------------------------------------
>
>
--
Eric Christison Msc
Mechanical Engineer
Consumer & Micro group
Imaging Division
STMicroelectronics (R&D) Ltd
33 Pinkhill
Edinburgh EH12 7BF
United Kingdom
Tel: +44 (0)131 336 6165
Fax: + 44 (0)131 336 6001
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|