Many years back (too many) I was working on silver epoxy connected hybrids
for high reliability applications.
I seem to recall that silver migration is a definite issue. Does anyone have
any rules for mitigating this risk such as design clearances between pads
etc?
Best regards,
John Burke
Director of Operations
http://www.optichron.com
4221 Technology Drive
Fremont, CA 94538
Cell (408) 515 4992
Desk (510) 249 5233
Main (510) 249 5200
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------