Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Thu, 25 Jun 2009 06:57:18 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Thanks everyone for your responses..... Now I'm off on an archeological hunt to see if our own fabrication shops will give us their capabilities.....
Thanks again,
Colleen
-----Original Message-----
From: Paul O Connor [mailto:[log in to unmask]]
Sent: Wednesday, June 24, 2009 4:51 PM
To: [log in to unmask]; Salvaggi, Colleen
Subject: Re: copper oz vs. minimum trace widths
Colleen,
I've designed a lot of boards with 2oz cu on both the internal & external
layers, I use 0,20mm spacing & 0,20mm minimum trace width. This brings the
designs into the manufacturing range of a broad range of fab shops.
Regards
Paul O' Connor CID+
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|