Ni hao charming,
That separation can occur during cooling from solder reflow [if too fast=thermal shock] or in your T-shock test [would have been good to give details.
Your TSSOP leads are likely Alloy42 [=very stiff] and are very stubby [=very stiff] with SAC-solder [=very stiff].
In T-shock it is NOT any CTE-mismatch that causes your problem [even though it does not help, and may cause reliability problems with the product], but the thermal gradients resulting from T-shock and causing component/PCB warpage.
How to improve on that? EASY, do not do T-shock in production [slow cooling rate after reflow to 1.5C/sec or less] and in testing go less severe or no T-shock at all.
Werner
-----Original Message-----
From: Charming Chan <[log in to unmask]>
To: [log in to unmask]
Sent: Fri, 29 May 2009 4:45 am
Subject: [TN] Looking for opinions on separation/delamination between copper land and dielectric material.
Hello All,
Our guys ran a thermal shock test to verify solder joint reliability of a
TSSOP component. The micro-section shows that there is a minor crack at the
toe side of the solder joint and a separation(delamination) between the
copper land and the dielectric material.
My question is,
Where did the separation/delamination occur? PCB fab house, PCB assembly
house, or thermal shock test?
If the separation/delamination occurred at pcb fab house, then, what's the
possible root cause gonna be?
If the separation/delamination occurred at thermal shock test or pcb
assembly house, then, is it caused by CTE mismatch between pcb base
material, solder alloy, and gull-wing footprint? How to improve on that?
Brain storm, and any input is appreciated.
I will get the micro-section picture posted once I get it. Thank you all.
Best Regards
Charming Chan
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for
additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|