I need some shrink tubing labels made.  It's a relatively small order: too
large to do by hand, but nowhere near any industry definition of volume.
Should I try to invest in a Kroy-type tub printer or are there any shops out
there that will do a small volume run without costing me an arm and a leg?
In deference to the TechNet, reps should contact me offline.  Anyone else,
please feel free to offer suggestions!

 

Thank you, 

 

Eric Kalgren

Electrical Engineer

The Ferrite Co. Inc.

165 Ledge Street

Nashua, NH 03060

Phone 603-881-5234

Fax 603-881-5406

 



 

PRIVILEGED AND CONFIDENTIAL COMMUNICATION
This E-mail is covered by the Electronic Communications Privacy Act, 18 U.
S. C." 2510-2521 and is legally privileged.  The information contained
herein is confidential and is intended only for the use of the individual or
entity named above.  If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution or
copying of this communication is strictly prohibited.  If you have received
this transmission in error, please immediately notify the sender by
telephone or via e-mail and delete the original transmission including any
attachments without reading or saving in any manner.

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------