I don't wish to appear cynical but isn't this a case where that missing 
commodity, common sense, should be applied?

In any case, the operator can just push the safety glasses up to his/her 
forehead. (S)he will still be wearing them! Does your sacrosanct rule 
specifically forbid this?

For Goodness' sake!

Brian

Roger Mack wrote:
> We are implementing a mandatory safety glasses policy across all of 
> manufacturing. This will replace the requirement for use in just 
> designated areas.
> 
> How do you handle the use of microscopes with a safety glasses policy? Are 
> inspectors allowed to remove glasses while using microscopes? The current 
> issued glasses leave your eye too far from the eyepieces for a full view.
> 
> We do have a few of the Vision Engineering Lynx scopes, but most are Leica 
> or B&L stereo microscopes.
> 
> 
> Roger Mack  P.Eng. 
> Manufacturing Specialist
> Parker Hannifin Corporation
> Electronic Controls Division
> 1305 Clarence Avenue
> Winnipeg, MB  R3T 1T4 Canada 
> direct 204 453 3339 x373
> www.vansco.ca
> www.parker.com
> 
> 
> 
> 
> 
> PLEASE NOTE: The preceding information may be confidential or
> privileged. It only should be used or disseminated for the purpose
> of conducting business with Parker. If you are not an intended
> recipient, please notify the sender by replying to this message and
> then delete the information from your system. Thank you for your
> cooperation.
> 
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 15.0
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
> -----------------------------------------------------
> 

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------