Hi Roger - Our rules permit the inspectors to remove their safety glasses 
when using a microscope.

Dave Hillman
Rockwell Collins
[log in to unmask]




Roger Mack <[log in to unmask]> 
Sent by: TechNet <[log in to unmask]>
03/06/2009 09:05 AM
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
[log in to unmask]


To
[log in to unmask]
cc

Subject
[TN] safety glasses






We are implementing a mandatory safety glasses policy across all of 
manufacturing. This will replace the requirement for use in just 
designated areas.

How do you handle the use of microscopes with a safety glasses policy? Are 

inspectors allowed to remove glasses while using microscopes? The current 
issued glasses leave your eye too far from the eyepieces for a full view.

We do have a few of the Vision Engineering Lynx scopes, but most are Leica 

or B&L stereo microscopes.


Roger Mack  P.Eng. 
Manufacturing Specialist
Parker Hannifin Corporation
Electronic Controls Division
1305 Clarence Avenue
Winnipeg, MB  R3T 1T4 Canada 
direct 204 453 3339 x373
www.vansco.ca
www.parker.com





PLEASE NOTE: The preceding information may be confidential or
privileged. It only should be used or disseminated for the purpose
of conducting business with Parker. If you are not an intended
recipient, please notify the sender by replying to this message and
then delete the information from your system. Thank you for your
cooperation.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to 
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to 
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 
for additional information, or contact Keach Sasamori at [log in to unmask] or 
847-615-7100 ext.2815
-----------------------------------------------------


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------