Inge,
I purchased a used camera for myself, and it did not come with a manual.
Was able to buy one from this site:
http://manuals2go.com/
It came in the mail on a CD.
Good Luck,
Kevin
-----Original Message-----
From: Vladimir Igoshev [mailto:[log in to unmask]]
Sent: Tuesday, March 31, 2009 1:07 PM
To: [log in to unmask]
Subject: Re: [TN] Nikon microscope camera DXM-1200
Inge,
Have you checked ebay?
Vladimir
------Original Message------
From: Inge
Sender: TechNet
To: [log in to unmask]
ReplyTo: TechNet E-Mail Forum
ReplyTo: Inge
Sent: Mar 31, 2009 11:50
Subject: [TN] Nikon microscope camera DXM-1200
Hi all and a half,
anyone who happens to have such a one? I need a electric wiring diagram or a
service manual for the framegrabber board built for that camera. Nikon does
not give support and I don't like to pass such a good camera equipment to
the waste bin (best camera on the market when I bought it). The program
works, but the camera framegrabber window on the screen just shows a zigzag
pattern. Camera produces 1V p-p video signal on two wires and sync on the
third (Y), 12 frames a second, a variant on RGB. I know it's crazy to
repair on component level, but I use to at least make a try. Old habit. The
grabber manufacturer is not either service minded (TechnoMedia). You could
of course buy general framegrabber board for PCI slots, but then you just
get a picture and no tool box for annotation , measuring, picture options
etc.
/Inge
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To
unsubscribe, send a message to [log in to unmask] with following text in the
BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet
NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send
e-mail to [log in to unmask]: SET Technet Digest Search the archives of
previous posts at: http://listserv.ipc.org/archives Please visit IPC web
site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
SENTEC
11 Canadian Road, Unit 7.
Scarborough, ON M1R 5G1
Tel: (416) 899-1882
Fax: (905) 882-8812
www.sentec.ca
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
