Liu,

We use Altium/Protel here primarily for its relatively low cost and ease
of use.

My regards,
Steve Smith
Staco Energy Products Co.

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Deac Descoteaux
Sent: Monday, February 16, 2009 8:47 AM
To: [log in to unmask]
Subject: Re: [TN] Questionnaire

Hello Liu,

It is not as cut and dry as that. It really depends on how your
infrastructure is set up. SI, schematic capture, mfg. etc.
From a designers point of view, PADS is somewhat easy to learn, but has
certain drawbacks. Mentor and Cadence have a tremendous amnount of
capabilities, but more expensive and a little bit more difficult to
learn.

Jope this helps you.

Deac
----- Original Message -----
From: "Liu, Edwin" <[log in to unmask]>
To: [log in to unmask]
Sent: Sun, 15 Feb 2009 19:54:12 -0800
Subject: [TN] Questionnaire

> Questionnaire:
> 
> I guess that there have many engineers here,so which kind of software
do
> you like best to design the PCB?Why (Like as Protel,Power PCB)
> 

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------