Greetings,
I was just reviewing the Working Draft for the new IPC-7251 (Land Pattern
Standard)
http://www.ipc.org/committeedetail.aspx?Committee=1-13
and noticed the recommendation for holes being 0.15-0.25mm over max lead
diameter.
(depending on complexity level)
Has this ever been addressed before?
If so, does this match previous IPC recommendations?
Jack (aka "the new guy")
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------