Thanks for all of the great replies on the board cleaning question....

Here's another:

Purchasing is asking: When a fabricator panels a board and there are
x-outs within the panel, does that mean that the fabricator isn't
competent?

We have received 90% of our boards separated into single units and we
now have an assembler that wants the boards in a panel.  Some of the
boards in the panel are x-ed out.

I'm saying that x-outs are common enough, that more than one board is
usually not good enough to be used for production, but that is because
of the tight tolerances and difficult manufacturing methods.

Is that a good argument?

Bob Wilson
E/M Designer, CID+
SpectraSensors, Inc.
11027 Arrow Route
Rancho Cucamonga, CA 91730
(909) 948-4110
www.spectrasensors.com
www.ipc.org


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------