Subject: | |
From: | |
Reply To: | |
Date: | Fri, 12 Dec 2008 13:23:02 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Victor - I recommend going to the Leco Corporation website and contact
them about getting a copy of their "Metallography Principles and
Procedures" booklet, form 200-860. Their booklet is considered by many
folks to be the "bible" for metallography. The booklet contains multiple
etchant recommendations for all elements and metal alloy families. You
could try Tucker's etch: HCl (conc) 45ml, HNO3 (conc) 15 ml, HF (48%)
15ml, H2O 25 ml.
Dave Hillman
Rockwell Collins
[log in to unmask]
Victor Hernandez <[log in to unmask]>
Sent by: TechNet <[log in to unmask]>
12/12/2008 12:49 PM
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
[log in to unmask]
To
[log in to unmask]
cc
Subject
[TN] Cold Forged Alunium (CFA), Cross section-grain structure
Fellow TechNetters;
Is there anyone out there with experience with CFA cross section and
chemical etchants to delineate grain boundary? Do not have the
specific CFA alloy.
I used the following chemical etchant:
No. 5 Keller's etch HF (conc) 1.0ml
HCL (conc) 1.5ml
HNO3 (conc) 2.5ml
H20 95.0ml
Immerse for 10-20 sec; wash in stream of warm water, Microstructure of
duraluminum type alloy. 17ST, AND ALCLAD
Not able to se grain boundary.
vic,
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|