We are looking for a forming tool that isn't too expensive that will form a
standoff bend in dipped capacitors without deforming the lead. Due to some
height constraints we cannot use preformed parts from the capacitor
manufacturer.

We currently are using a hand tool but it deforms the lead diameter in the
lead bend by more than the 10% allowed in IPC-610.

These are small caps with a lead spacing of .40". The lead diameter is .023
and we need a small bend near the body of the part.

We've considered Diso Pads but due to the tight location of the parts they
would be very difficult to stuff. If any of you know of an easier way to
keep the meniscus out of the holes I'd love to hear about it.

Thanks,

KennyB

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------