Subject: | |
From: | |
Reply To: | |
Date: | Wed, 1 Oct 2008 20:44:55 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Anand
Flash gold plating is widely available in Asia and is being used as a
alternative to ENIG. This has been in place since early 2000s. The thickness
is about 2 micro inches. I have worked with several OEMs using this coating
for aluminum wire bonding and the results have been positive. Of course, if
the process is not properly controlled, you may have serious problems. I
always recommend continuing due diligence and incoming inspection with any
supplier.
Best regards
Lee
JLP Consultants LLC
804 779 3389
----- Original Message -----
From: "Anand" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, October 01, 2008 5:02 PM
Subject: [TN] Electrolytic (Flash) Nickel Gold Finish
Hi All,
I want to use Alluminum WEDGE wire bonding for COB.
as the ENIG is suitable only for Gold Wire Bonding .....! which i don't
want.
I thought about Electrolytic (Flash) Nickel Gold Finish. as alluminum wire
bond
can be used.
but i don;t know the recommended thickness of nickel and Gold for
A) Electrolytic ?????? I didn't found any ipc std for this ?
B) Can any ONE please guide me for the thickness of this plating....!
C) again as there is no phosphurus used in electrlytic process how can we
prevent the corrosion for this plating ?
thanks and eagerly waiting for the answer on above three questions .....
Regards,
Anand
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|