Good Friday to all,

I was asked by one of my design engineers:

What is considered as standard laminate thickness, if such exists, for
cores and layers?
What is the cost incurred when non-standard thickness are specified?

I usually bounce these questions off my PWB suppliers, but thought I
would broaden my input.  Any assistance would be appreciated.


Best regards,

Gary 

Gary Camac
Senior Manufacturing Engineer
DICKEY-john Corp.
5200 Dickey John Road
Auburn, IL 62616-0010
Telephone 217-438-2288



---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------